Eureka 6830 SERIES - Manual (Page 4)

To remove used dust bag and check filters:
1. Unplug the hose from the bag compartment lid.
2. Squeeze bag compartment latch and swing lid up.
3. Lift exhaust filter out of bag compartment. If dirty, clean
or replace. The filter can be cleaned by brushing over a
waste receptacle. Place filter back in bag compartment.
4. Grasp bag collar and lift used bag out of cleaner and throw
away.
5. Pull down on motor filter grille to release the motor filter.
If dirty, clean or replace. The filter can be cleaned by
brushing over a waste receptacle. Replace filter in grille,
rotate grille up and push against cleaner to latch.
To install disposable dust bag:
1. Hold dust bag by collar and push dust bag into bag
frame.
2. Rotate bag compartment lid down and press against
cleaner until it latches.
Brush Roll
The brush roll turns to sweep and comb the carpet nap. Keep
the brush roll free from hair and threads so it will continue
cleaning. When the bristles of the brush roll no longer touch
a piece of cardboard held across the bottom plate, the brush
roll is ineffective because the bristles no longer touch the
carpet nap. To maintain the most effective cleaning, install a
new brush roll.
POWER-TOUCH ® Handle
Remote ON/OFF Selector for bare floor or carpet
ON – push down on front
*Off – push down on back for bare floors.
Vacuum Control
Cleaning suction is reduced by pushing lever to
LOW position. Place lever at HIGH position to
increase suction for carpet cleaning.
4
HOW TO USE (continued)
ON
OFF
Dusting Brush (stored inside cleaner):
For furniture, blinds, books, lamp shades,
shelves.
Upholstery Nozzle (stored inside cleaner):
For curtains, draperies, cushions, fabrics.
Crevice Tool (stored inside cleaner): For
crevices, corners, baseboards, between
cushions.
Cleaning Tools
HOW TO MAINTAIN
The paper bag and filters play a very important role in the
efficiency of the vacuum cleaner. The purpose of the paper
bag is to trap dirt and at the same time the paper must be
porous enough to allow air to pass through. If the paper bag
or filters become clogged, no air can pass through the cleaner
and no cleaning takes place regardless of how powerful the
unit. To keep the cleaner operating at maximum efficiency,
change the dust bag frequently and clean the filters as
necessary.
Some fine particles can restrict airflow very quickly and will
decrease performance even before the bag appears to be
full. When vacuuming carpet fresheners or cleaners, plaster
dust, or similar fine substances, clean the bag and filters
more often.
Bare Floor Brush: (on some models) For any type
of hard surface floor.
Turbo Brush: (on some models) For upholstery
and for stairs.
3. 4. 5.
*Power ON/OFF for canister can only be controlled by canister
ON/OFF switch.
Filled Bag Empty Bag
Bag Change Indicator
The bag change indicator bar fills as the airflow through the
bag decreases. Certain types of fine particles like powder,
plaster dust, or carpet fibers can restrict airflow very quickly
and will decrease performance even before the bag appears
to be full. When the warning appears, change the disposable
dust bag to restore maximum performance. If a clean dust
bag does not restore maximum performance, clean the filters
and check the hose and wands for obstructions.
HOW TO CHANGE DISPOSABLE DUST BAG
- Style CN2 and FILTER - Style EF3
NOTE: Turn off the power switch and disconnect
electrical cord from wall socket before
changing dust bag. Never use the cleaner
without a dust bag or filters.