beautypg.com

When the new washer-dryer arrives, Installation, Warning – Equator EZ2512CEE User Manual

Page 7: Grounding instructions, Electrical requirements

background image

After removing the appliance from its packaging, check that it

is intact. If in doubt, contact Equator immediately. The inside
of the machine is supported, for transportation, by four
shipping bolts on the back panel.

Before using the washer-dryer,

remove the external

shipping bolts,

remove the spacers together with the rubber

tubes attached to them (save all the parts) and use the plastic

blanking plugs provided to fill in the holes. Use the wrench

provided to remove the external bolts.

Attach the two rubber hoses provided

to the red (hot) and

white (cold) water inlets on the back (top right) or the appliance.

Connect the other ends to the appropriate built-in water supplies or a

Y-adapter / Faucet Adapter combination to a single source (like a kitchen

faucet.). Using the “U”-Connector provided, place the drain hose into the

drain pipe (or the sink.) See Plumbing on Pg. 7 for more details.

Leveling

The washer-dryer must be levelled appropriately in order to

guarantee its correct functioning. To level the appliance, the front

feet must be adjusted; the angle of inclination, measured according

to the worktop, must not exceed 2°.

WARNING

!

Excessive Weight Hazard

Use two or more people to move

and install your appliance.

Failure to do so can result in

back or other injury

The front feet are self-locking & adjustable

Instructions for installation and use

6

When the new washer-dryer arrives

Installation

Whether new or just transported to a new house, installation is extremely important
for the correct functioning of your washer-dryer.

For your own protection, and to prevent accidents, injury and

fire, please read the following carefully:

1.

Destroy the carton and plastic bags, after the washer-dryer

has been unpacked.

2.

Children should never be left alone or unattended in the

area where appliances are located.

3.

Washer installation and grounding must be done in

accordance with local codes by a qualified installer. Installation

instructions are packed in new washer to the installer’s

reference.

4. ONLY the Equator Low Sudsing detergent is recommended

for this appliance. To order your box of Equator detergent call
1-800-935-1955

.

5.

The washer must be plugged into a properly grounded 3-

prong electrical outlet. For your safety, the third or round

grounding prong must never be removed.
DO NOT USE AN EXTENSION CORD.

6.

Repair or replacement of a part should be made only by a

qualified service technician to prevent personal injury or damage

to the machine. For a list of authorized repair service agents,

call Equator Service at 1-800-776-3538.

7.

Disconnect power to the washer at the circuit breaker or

fuse box, or unplug the machine in an emergency when

servicing is required. Have the installer show you and label the

proper switch or fuse at the electrical disconnect box.

WARNING - The Appliance should be connected to an
Individual Branch Circuit with N.. 14 AWG Wire and
Protected by 15 A Fuse.

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of malfunction,

or breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current. This

appliance is equipped with a cord having an equipment-

grounding conductor and grounding plug. The plug must be

plugged into an appropriate outlet that is properly installed and

grounded in accordance with all local codes and ordinances.

WARNING -

Improper connection of the equipment-grounding

conductor can result in a risk of electric shock. Check a qualified

electrician if you are in doubt as to whether the appliance is

properly grounded.

Do not modify the plug provided with the appliance. If it will not

fit the outlet, have a proper outlet installed by a qualified

electrician.

Retain the shipping bolts, spacers and washers.

Should you move residence then these should be

replaced to support the inside of the machine to

prevent damage when transporting the machine.

Warning !

The company denies all liability if and when these

instructions are not respected. Plastic bags,

expanded styrofoam, nails and other packaging

parts are not children’s toys, are potentially

dangerous and should be disposed off properly.

WARNING

!

Electrical Requirements

Electrical Shock Hazard (death, fire or electrical shock):

1) Plug into a grounded 3 prong outlet.

2) Do not remove ground prong.

3) Do not use an adapter or an extension cord.