Electrolux 40250 i - Manual (Page 22)

Operating Instructions
22
Interrupting the wash programme by opening the door of the dish-
washer
1 Hot steam may escape when the door is opened. Open the door care-
fully.
0 1. Open the door of the dishwasher. The wash programme stops.
2. Shut the door. The wash programme continues.
Switching Off the Dishwasher
When the wash programme is finished:
0 1. Turn the program selector to the I position. Power indicator light goes
out.
1 Hot steam may escape if the door is opened immediately after the end
of the programme. Therefore:
2. Open the door carefully.
Emptying the Dishwasher
3 • Hot dishes are sensitive to knocks. The dishes should therefore be
allowed to cool down before removing them from the appliance.
• The dishes will dry quicker if, when the programme has finished, you
briefly open the door fully and then leave it slightly ajar.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• Empty the lower rack first, then the upper rack. In this way you will
avoid any water left on the upper rack dripping onto the dishes in the
lower rack and causing water spots.
Care and Cleaning
1 Do not under any circumstances use furniture care products or aggres-
sive cleaners.
• If necessary, clean the controls only with a soft cloth and pure warm
water.
• The spray arms do not need cleaning.
• Occasionally check the internal containers, door seal, and water inlet
for soiling, clean if necessary.