RCF Active 2200W 3-Way Line Array Module with 4 Channels of Class-D Amplification - Manual (Page 10)

10
ENGLISH
At this point you can connect the power supply cable and the signal cable, but before turning
on the speaker make sure that the volume control is at the minimum level (even on the mixer
output). It is important that the mixer is already ON before turning on the speaker. This will avoid
damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a
good practice to always turn on speakers at last and turn them off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level.
BEFORE TURNING ON
THE SPEAKER
WARNING: daisy chaining speakers always make sure that the maximum current
requirement does not exceed the maximum admitted POWERCON current. In case of doubt
call the closest RCF SERVICE CENTRE.
WARNING
INSTALLATION
WARNING: The powercon connector is used to disconnect the system from the power
supply network. It shall be easily accessible after the installation and during the use of the
system.
The pickup point is asymmetric and can be
fit in two positions (A and B).
A position brings the shackle to the front.
B position allows an intermediate step
using the same fixing holes.
A B
5. Pickup fixing holes
5
1. Front flying bracket
2. Quick lock pin hole (to be used to lock the
front bracket before installation)
3. Loose pin hole
4. Suspension case pin hole
3
2
1
4
Move the pickup bracket to set system with
chosen angle.
The fuse settings/replacement shall be as follow:
FUSE VALUE T 6.30 A H 250 V
VOLTAGE SETUP
(RESERVED TO THE RCF SERVICE CENTRE)
SERVICE NOTE
1. FLYBAR INSTALLATION