RCF TT20-CXA Active Dual 8" 2-Way 1000W Monitor - Manual (Page 8)

8
ENGLISH
WARNING
To reset the speaker to the original settings :
-
turn on the speaker (the Power LED will blink slowly)
- while the Power Led is blinking, press and release several times the Bypass /
Local Setup button
- the Power LED wil now start blinking faster, this means the system accepted
the reset command
The XLR connectors use the following AES standard:
PIN 1 = GROUND (SHIELD)
PIN 2 = HOT (+)
PIN 3 = COLD (-)
SPEAKER RESET
HOT GND
BAL. XLR
COLD
CONNECTIONS
11 AC POWER INPUT. Powercon locking 3-pole AC mains.
12 AC OUTPUT LINK. Powercon locking 3-pole AC mains output.
WARNING : the Powercon connector is used to disconnect the system from the power supply
network. It shall be easily accessible after the instillation and during the use of the system.
At this point you can connect the power supply cable and the signal cable, but before turning
on the speaker make sure that the volume control is at the minimum level (even on the mixer
output). It is important that the mixer is already ON before turning on the speaker. This will avoid
damage to the speakers and noisy “bumps” due to turning on parts on the audio chain. It is a
good practice to always turn on speakers at last and turn them off immediately after the show.
Now you can turn ON the speaker and adjust the volume control to a proper level. BEFORE TURNING ON
THE SPEAKER
WARNING: daisy chaining speakers always make sure that the maximum current
requirement does not exceed the maximum admitted POWERCON current. In case of doubt
call the closest RCF SERVICE CENTRE.
WARNING: The powercon connector is used to disconnect the system from the power
supply network. It shall be easily accessible after the installation and during the use of the
system.
INSTALLATION
WARNING
The fuse settings/replacement shall be as follow:
FUSE VALUE T 6.30 A H 250 V
SERVICE NOTE
VOLTAGE SETUP
(RESERVED TO THE RCF SERVICE CENTRE)
11 12