Exmark Turf Tracer S-Series TTS16KA363CA - Manual (Page 30)

Maintenance
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with NGLI grade #2
multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number of Places Service
Interval
36 inch
Deck
48 inch
Deck
52 inch
Deck
1. Caster
Wheel
Bearings 12 2 2 2 Daily
2. Caster
Pivots 2 2 2 2 Daily
3. PTO
Engagement
Bellcrank 1 1 1 1 40 hours
4. Pump
Drive Idler
Pivot 2 1 1 1 Yearly
5. Clutch
Arm Pivot 1 1 1 1 40 hours
6. Pump
Control
Bearings 2 2 2 2 40 hours
7. Mower
Deck Idler
Pivots 2 1 1 1 Yearly
Number 4 Idler Pivot (Pump Drive) Located
under engine deck.
Number 5 (Clutch Arm Pivot) Located under
engine deck.
3. Lubricate pivot points with a spray penetrating
lubricant as shown in the Spray Lubricant Chart.
Spray Lubricant Chart
Spray Lubricant Chart (cont'd.)
Pivot Point Number of Places Service Interval
1. PTO Lever 1 40 hours
Check Spark Plugs
Service Interval: Every 160 hours
Remove spark plugs, check condition and reset gaps,
or replace with new plugs. See Engine Owner’s
Manual.
Change Fuel Filter
Service Interval: As required
A fuel filter is installed in the fuel line between the
fuel tank and the engine. Replace when necessary.
Change Hydraulic System
Filter
Service Interval: After the first 250 hours
Every 500 hours/Yearly
(whichever comes
first) thereafter
(Every 250 hours/Yearly if
using Mobil 1 15W50)
Note: Use only Exmark Part No. 109-4180 for
Summer use above 32°F (0°C) or P/N 1-523541 for
Winter use below 32°F (0°C) (Refer to Transmission
section in Specifications for filter specifications).
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Carefully clean area around filter. It is important
that no dirt or contamination enter hydraulic
system.
3. Unscrew filter to remove and allow oil to drain
from reservoir.
Important: Before reinstalling new filter,
fill it with Exmark Premium Hydro Oil and
apply a thin coat of oil on the surface of the
rubber seal.
Turn filter clockwise until rubber seal contacts the
filter adapter, then tighten the filter an additional
2/3 to 3/4 turn.
4. Fill reservoir as stated in Check Hydraulic Oil
Level.
30