Emerson CF712WB01 - Manual (Page 8)

Installing The Light Fitter
And Glass
1. Remove and retain the three screws securing the
switch housing cover to the switch housing.
(Figure 14) Remove and retain the two wire
connectors. Remove plug screw.
2. Remove and retain the lockwasher and nut from
the light fitter. Insert the black and white wires from
the light fitter through the center hole in the switch
housing cover. Thread the switch housing cover
onto the light fitter. Reinstall the lockwasher and
nut and tighten securely (Figure 15).
3. Connect the white wire from the ceiling fan to the
white wire of the light fitter (Figure 15). Connect
the blue wire from the ceiling fan to the black wire
of the light fitter. Use wire connectors (previously
removed) to make connections.
4. Carefully tuck all wires and splices into the switch
housing.
8
SCREW (3)
SWITCH
HOUSING COVER
SWITCH
HOUSING
REMOVE AND RETAIN
THE TWO WIRE
CONNECTORS
PLUG SCREW
Figure 14
CAPTIVE
SCREW (2)
BLADE FLANGE
ALIGNMENT
SLOT
MOTOR HUB
Figure 13
2. Mount one blade assembly to the motor hub by
mating the alignment post (Figure 12) of the flange
with one of the alignment slots in the motor hub
(Figure 13). Then tighten the two captive screws in
the flange to secure the flange to the motor hub.
Repeat this procedure for the other four blade
assemblies. Make sure all screws are tightened.
5. Attach the switch housing cover with light fitter to
the switch housing using the three previously
removed screws.
6. Install three 60-watt (maximum) candelabra base
light bulbs (not supplied) into the light fitter sockets
(Figure 16).
7. Remove the finial nut and outer bowl cap from the
light fitter (Figure 16).
8. Pass the fan switch chain through the bushing in
the bowl cap (Figure 16).
To avoid fire or electrical shock, be careful not to
pinch wires between the switch housing assembly
and the cover.
WARNING !
SCREW (3)
SWITCH
HOUSING
COVER
BLACK WIRE
BLUE WIRE
WHITE WIRE
WHITE WIRE
WIRE
CONNECTOR
WIRE
CONNECTOR
NUT
LOCKWASHER
LIGHT FITTER
Figure 15
To avoid possible fire hazard, do not exceed wattage
indicated on the fitter.
WARNING !
THREADED NIPPLE
BOWL CAP
LIGHT FITTER
OUTER BOWL CAP
GLASS BOWL
60-WATT
CANDELABRA
BASE BULBS (3)
FINIAL NUT
FAN SWITCH
CHAIN
PENDANTS (2)
LIGHT SWITCH
CHAIN
Figure 16