EverFocus COLOR DOME ED300E - Manual (Page 5)

4
○
12 Power input
Please connect the connector of camera to 12VDC or 24VAC power source.
○
13 Video Output BNC Connector
Please connect to the BNC connector of Monitor video in.
INSTALLATION
1. Remove the plastic dome cover.
2. Lossen the two screws of the supporting bracket to remove the camera body.
3. Use four screws to fix the camera base on the ceiling.
4. Put the camera body back to the supporting bracket, then tighten the two screws to
fix the camera.
5. Connect the BNC connector of the camera to a color monitor, or other video device
through a 75 ohm type coaxial cable with BNC female connector at cable
extension.
6. Connect the 12VDC or 24VAC power source to the power jack of camera.
NOTE: Please do not scratch or damage the lens while making any kind of setting.