Electrolux DTC50GA - Manual (Page 21)

You can wash the removable parts in very hot soapy water. You may
use mild abrasives. Make sure that the electrode and the hole and slots
in the crown are not blocked with food or cleaning materials.
Clean the burner crowns by soaking them in very hot soapy water.
You can remove any stubborn stains by scouring with a soap filled pad
such as 'Brillo'. If you look after the burner crowns in this way they will
stay reasonably clean. However the surface will dull with time.
Aluminium based saucepans can leave shiny metal marks on the pan
supports. Clean the pan supports regularly to remove the marks using a
mild abrasive like 'Cif' with a soft scourer. For more stubborn marks you
can use a soap-filled pad such as 'Brillo'.
After cleaning the appliance parts, dry
them thoroughly before you put them back.
When replacing hotplate burner parts
1. Crown to body (Do not try to force
the crown on to the body).
Make sure that the hole in the crown
is over the electrode. Check that the
two longer location pegs sit in the
slots in the body. When the crown is
in this position let it fall freely on to
the body. Check that the crown can
be moved slightly from side to side.
2. Cap to crown
Place cap centrally on the top of the
crown (enamel side up). Move
sideways and front to back to check
the cap is properly fitted.
3. Check for ignition
If a burner will not light then you
need to check the crown and cap
positions.
21
D T C 5 0 G A
Care and cleaning