Electrolux EWT 106411 W - Manual (Page 6)

“Start/Pause” pushbutton. After closing
the lid again, press the “Start/Pause”
pushbutton.
TIME MANAGER
The cycle can be made longer or shorter by
using the “Time Manager”
pushbuttons.
The level of soiling of the laundry is also in-
dicated.
Soil level Icon Type of fabric
Intensive For heavy soiled
items
Normal For normal soiled
items
Daily For daily soiled items
Light For slightly soiled
items
Quick 1) For very slightly
soiled items
Super quick 1) For items used or
worn for a short time
Refresh 1) 2) For refreshing items
only
Super re-
fresh
1)
2) For refreshing a very
few items only
1) To use on a half load.
2) The symbol flashes and disappears : this wash cycle
is a refresh cycle only.
The availability of these different levels var-
ies depending on the selected programme
type.
START OF THE PROGRAMME
Press the “Start/Pause”
pushbutton to
start the cycle ; the corresponding light will
come on green. It is normal for the pro-
gramme selector to remain stationary dur-
ing the cycle. The symbol for the current
cycle and the remaining time appear on the
display. If a delayed start has been selec-
ted, the countdown appears on the display.
The drain pump can operate for a short
time when the appliance fills water.
WARMING UP
During the cycle, the symbol comes on
when the appliance is reaching the right
temperature.
INTERRUPTING A PROGRAMME
Adding washing
When the “Add washing” light
is on, you
can add washing by proceeding as follows.
Press the “Start/Pause”
pushbutton :
the corresponding light will flash green while
the appliance is paused. The lid can only be
opened around 2 minutes after the washing
machine has come to a stop. Press the
“Start/Pause”
pushbutton again to con-
tinue the programme.
Modifying the programme in progress
Before making any changes to the current
programme, you need to pause the wash-
ing machine by pressing the “Start/Pause”
pushbutton. If the modification is not
possible, “Err” flashes in the display and the
“Start/Pause”
pushbutton flashes red for
a few seconds. If you still decide to change
the programme, you must cancel the cur-
rent programme (see below).
Cancelling the programme
If you want to cancel the programme, turn
the programme selector to the “Stop” posi-
tion .
END OF THE PROGRAMME
The washing machine stops automatically ;
the “Start/Pause”
button goes out and
flashes on the display. The lid can only
be opened around 2 minutes after the
washing machine has come to a stop. Turn
the programme selector to the “Stop”
position. Remove washing. Unplug and
close water inlet tap.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
6 electrolux