Electrolux LAVAMAT 74810 - Manual (Page 20)

20
E10 appears.
The END indicator
flashes 1x, and an
acoustic signal sounds
1x.
(Problems with water
inflow.) Tap turned off. Turn on the tap.
The filter in the threaded
inlet hose fitting is blocked.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Water tap is furred with
lime scale or is faulty. Check the tap and have it
repaired, if necessary.
The washing machine
vibrates when operating
or is not stable.
The transit packaging has
not been removed. Removing the transit
packaging.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and
connection instructions.
Washing has not been
spun. Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is running out
from under the washing
machine.
Screw connection on the
inlet hose is leaking. Screw the inlet hose on
tightly.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door. Load washing carefully for
the next wash.
Emergency drain hose is
leaking. Close off emergency drain
hose properly.
Wash water is foaming
excessively. At the
end
of the washing cycle,
the spin stops. The
OVERDOSING indicator
lights up. Too much detergent has
probably been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
E20 appears.
The END indicator
flashes 2x, and an
acoustic signal sounds
2x.
(Problems with water
inflow.)
Kink in drain hose. Straighten the hose.
Do not exceed the
maximum pump height of
1m.
Please contact customer
service.
Drain pump is blocked.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump.
Remove foreign bodies from
the pump housing.
For sink spigot connections:
The sink spigot is blocked.
Clean the sink spigot.
Problem Possible cause Remedy