Attachment use chart, Operating instructions – Euro-Pro SHARK EP825 User Manual

Page 5

5. Changing the Head Light Bulb:

Warning: Always disconnect from

power source when servicing or

cleaning the unit. Failure to do so

could result in electrical shock or

personal injury from cleaner suddenly

starting.

• Turn unit “Off” and unplug from

wall outlet.

• Insert the edge of a flat edge

screw driver into the locking tab

on the headlight lens and pull the

handle of the screw driver

towards you. Do NOT push with

the blade of the screw driver

against the lens because it might

cause it to break.

• Remove the lens. (Fig. 12)

• Remove the light bulbs by pulling

them out carefully.

• Push the new light bulbs in and

replace the lens cover.

• Make sure that it snaps in place.

Note: Always replace the light bulb with

the same or smaller wattage size (12V

4W) to prevent damage to the

surrounding parts.

Lens locking tab

Fig. 12

WARNING: When the vacuum is

turned on, the beater brush will

continue to rotate. Avoid tipping

the vacuum or setting it on furniture,

fringed area rugs or carpeted stairs

while you are using the hose with the

attachments. Avoid leaving the

vacuum is one place for an extended

period of time, particularly on thick

carpet.

Extension

Tube (2)

Crevice

Tool

Dusting

Brush

Hose

Connector

IMPORTANT: If the bag is not
inserted correctly into the housing, the
cover will not close. Please make
sure that the bag is inserted all the
way in until the latch catches
otherwise front cover will not close.

Warning

• Always turn vacuum "Off" before

attaching the accessories.

• Do NOT place hands or feet

underneath the agitator brush at

any time. When using the

attachments, the agitator brush

continues to rotate.

• Do NOT allow the vacuum cleaner

to remain in just one place for a

long period of time as the agitator

may damage the floor surface.

• NEVER place the vacuum cleaner

on furniture, the fringed area of

rugs, deep pile carpeting or

carpeted stairs. The ideal position

for the vacuum cleaner when

using any attachment is for the

unit to be on a level surface with

the handle in the upright position

and the carpet height adjustment

knob in HIGH.

ATTACHMENT USE CHART

Using the Attachments

Fig. 3

Motor Thermostat

Important:

This unit is equipped

with a motor protective thermostat. If

for some reason the vacuum cleaner

should overheat, the thermostat will

automatically turn the unit off. Should

this occur:

•

Push the On/Off button once.

• Disconnect the plug from the

power source.

• Check the source of overheating

problem. (i.e. clogged hose or

filter)

• If clogged hose or filter is found,

unclog the hose and replace the

filters.

• Wait at least 45 minutes before

attempting to reuse the vacuum.

• After unit has cooled down for

45 minutes, plug in the cleaner

and push the On/Off button. The

vacuum should start again.

• If the vacuum still does not start,

contact customer service at

1-800-798-7398.

OPERATING INSTRUCTIONS

1. Place vacuum in its upright position.

2. Make sure that the vacuum cleaner

is NOT plugged into the electrical

outlet.

3. Turn the carpet adjustment knob to

the high pile position.

4. Pull the hose connector from the

rear of the vacuum and push the

desired attachment firmly onto the

end of the hose. (Fig. 3)

5. If additional length is required,

attach one or both of the extension

tube to the end of the hose and then

attach the crevice tool or dusting

brush to the end of the extension

tube.

CLEANING AREA

ATTACHMENT

Furniture

Between

Cushions

Drapes

Stairs

Walls

DUSTING

BRUSH

CREVICE

TOOL