Electrolux EDC 77150W - Manual (Page 20)

20 electrolux something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes to
indicate that the machine is not working.
Once the problem has been eliminated, press the Start/Pause button to restart the
programme. If after all checks, the problem persists, contact your local Service
Centre.
Malfunction Possible cause Solution
Dryer does not work.
● Mains plug is not plugged in
or fuse is not working
correctly.
●
Loading door is open.
● Have you pressed the
START/ PAUSE button?
●
Plug in at mains socket.
Check fuse in fuse box
(domestic installation).
● Close loading door.
● Press the START/PAUSE
button again.
Drying results
unsatisfactory. ● Wrong programme selected.
●
Lint filter clogged.
● Heat exchanger clogged with lint.
● Incorrect volume of laundry.
● Ventilation slots in base area
covered up.
● Residue on inside surface of
drum or drum ribs.
● Conductance of water at
installation site differs from
standard setting of machine.
● Select a different programme the
next time you dry (see “Overview
of programmes” section).
● Clean lint filter.
● Clean heat exchanger.
● Observe recommended
loading volumes.
● Uncover ventilation slots in
base area.
● Clean inside surface of drum
and drum ribs
● Re-programme standard setting
for degree of drying (see
‘Programming options’ section).
Loading door does not
close.
● Fine strainer not in place
and/or large mesh filter not
locked in place. ● Install fine strainer and/or
snap large mesh filter into
place.
125985630 gb.qxp 2006-07-20 08:30 Page 20