Extron electronic Extron MediaLink MLS 304SA - Manual (Page 4)

■ High bandwidth – 280 MHz (-3 dB) RGB video bandwidth
maintains signal integrity.
■ Flexible video and stereo audio inputs – Inputs one and two
accept composite video and stereo audio, and are on RCA
connectors. Inputs three and four accept computer-video or
composite video and stereo audio, and are on female 15-pin HD
and 3.5 mm stereo mini jacks.
■ Versatile video outputs – The MLS 304MA and MLS 304SA
include dual RGB outputs. One is on five BNC connectors and the
second is on a female 15-pin HD connector. The 15-pin HD can
also be utilized as a buffered local monitor loop-through for the
signal connected to input four.
■ Balanced audio – Balanced or unbalanced audio is output on
captive screw connectors. The two line level outputs (one fixed
and one variable) can be set for mono or stereo.
■ Integrated audio amplifier – The MLS 304MA provides 20 watt
(rms) amplified mono audio output on captive screw terminals for
a 4 or 8 ohm load or 70/100 volt distributed audio system. The
MLS 304SA provides 24 watts (2 x 12 watts rms) for 4 ohm
speakers and 16 watts (2 x 8 watts rms) for 8 ohm speakers.
■ Auxiliary/Mix audio – An additional input accepts mono line
level audio signals for mixing with any of the four switchable
inputs.
■ Volume control – Adjustable locally from the front panel or
remotely when integrated with a MediaLink Controller or a third
party RS-232 based control system.
■ Loudness control – A unique audio feature of the MLS 304MA
and MLS 304SA that compensates for the normal decreased
hearing ability of the human ear at low volume levels by
automatically boosting the low and high frequencies.
■ Triple-Action Switching ™ (RGB delay) – Blanks the screen
during switching of RGB signals to eliminate visible switching
transitions.
■ Front panel security lockout – Allows security lockout of front
panel buttons and/or volume adjustment.
■ Remote control – The MLS Series Switchers are designed to work
with a MediaLink Controller. They can also be controlled via the
front panel or any third-party RS-232 based control system.
■ Rack-mountable – The MLS 304MA and MLS 304SA are housed
in a 1U, full rack width metal enclosure.
■ Internal international power supply
The Extron MLS 304MA and MLS 304SA MediaLink ™ Switchers are
simple-to-use, four input, multi-format active switchers with audio
amplifiers. Designed as economical solutions for single-projector
classrooms and conference rooms, both models provide composite
video, computer-video, and audio switching.
The MLS 304MA and MLS 304SA include two inputs for composite
video with stereo audio on RCA connectors and two inputs for
computer-video with stereo audio on 15-pin HD connectors and
3.5 mm stereo mini jacks. Inputs three and four, both on 15-pin HD
connectors, are also configurable for computer-video, as well as
composite video. The switchers are equipped with dual RGB outputs.
One is on five BNC connectors and the other is on a 15-pin HD
connector. The 15-pin HD connector can also be utilized as a
buffered loop-through of input number 4 for a local monitor,
eliminating the need for a distribution amplifier and simplifying
operations.
MediaLink Switchers are designed to be used in conjunction with a
MediaLink Controller to facilitate low-cost integration. They can also
be used as stand-alone switchers.
Audio
For audio, each switcher includes two line level outputs (one fixed
and one variable) that can be configured for mono or stereo output
via RS-232. The MLS 304MA provides a 20 watt (rms) amplified
mono audio output on screw terminal for a 4 or 8 ohm load or
70/100 volt distributed audio system.
The MLS 304SA provides 24 watts (2 x 12 watts rms) for 4 ohm
speakers and 16 watts (2 x 8 watts rms) for 8 ohm speakers. Like the
line level outputs, the integrated audio amplifier can be configured
for stereo (default) or dual mono output via RS-232.
S
PECIFICATIONS F
EATURES
D
ESCRIPTION
VIDEO
Gain...................................................... Unity
Bandwidth ............................................ 280 MHz (-3 dB)
Differential phase error.......................... 1.0º at 3.58 MHz and 4.43 MHz
Differential gain error ............................ 1.0% at 3.58 MHz and 4.43 MHz
Crosstalk .............................................. -68 dB @ 10 MHz, -39 dB @ 100MHz
Switching speed.................................... 5 ms (max.)
VIDEO INPUT AND LOOP-THROUGH
Number/signal/connectors.................... 2 RGBHV, RGBS, RGsB, RsGsBs on 15HD
1 RGBHV, RGBS, RGsB, RsGsBs local monitor
loop-through on 15HD
2 composite video on RCA
Nominal level........................................ 1 V p-p for composite 0.7 V p-p for RGB
Impedance............................................ 75 ohms
Horizontal frequency ............................ 15 kHz to 145 kHz
Vertical frequency.................................. 30 Hz to 170 Hz
Return loss
RGB.................................................. <-40 dB @ 5 MHz
Composite video.............................. <-40 dB, 0 to 10 MHz
VIDEO OUTPUT
Number/signal/connectors.................... 1 RGBHV, RGBS, RGsB, RsGsBs on BNCs
1 composite video on BNC
Nominal level........................................ 1 V p-p for composite video, 0.7 V p-p for RGB
Impedance............................................ 75 ohms
Return loss ............................................ <-40 dB @ 5 MHz
Switching type ...................................... Triple-Action (RGB delay)
SYNC
Input/output type ................................ RGBHV, RGBS, RGsB, RsGsBs (follows input)
Standards.............................................. TTL (RGB), NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level ............................................ 0.5 V to 5.0 V p-p
Output level.......................................... TTL: 5.0 V p-p, unterminated
Input impedance .................................. 510 ohms
Output impedance................................ 75 ohms
Max input voltage ................................ 5.0 V p-p
Max. propagation delay ........................ 30 ns
Max. rise/fall time ................................ 4.0 ns
Polarity.................................................. Positive or negative (follows input)
AUDIO
Gain...................................................... Unbal. output: 0dB; bal. output: +6dB
Frequency response
Preamp/Lineout .............................. 20 Hz to 20 kHz, +0 dB/-0.15 dB
Direct (4/8 ohm).............................. 20 Hz to 20 kHz, +0 dB/-0.5 dB @ 1 W
Transformer (70V mono amplifier)...... 50 Hz to 20 kHz, +0 dB/-0.3 dB @ 1 W
Transformer (100V mono amplifier) .... 50 Hz to 20 kHz, +0 dB/-3 dB @ 1 W
THD + Noise
Power amp (mono or stereo)
8 watts/8 ohms ........................ <0.05% @ 1 kHz, 20 kHz bandwidth
12 watts/4 ohms ...................... <0.25% @ 1 kHz, 20 kHz bandwidth
Preamp/Lineout .............................. <0.07% @ 1 kHz, 20 kHz bandwidth
S/N at maximum power output (unweighted)
Power amp ...................................... >80 dB @ 10 Hz to 22 kHz
Preamp/Lineout .............................. >90 dB @ 10 Hz to 22 kHz
Crosstalk .............................................. <-80 dB @ 1 kHz, fully loaded
Stereo channel separation .................... >80 dB @ 1 kHz
CMRR.................................................... >75 dB @ 20 Hz to 20 kHz
AUDIO INPUT
Number/signal/connectors.................... 2 stereo, unbal. line level on RCA (input 1-2)
2 stereo, unbal. line level on 3.5 mm TRS
(input 3-4)
1 mono, bal./unbal. line level on 3.5 mm captive
screw (aux/mix input)
Impedance............................................ >10 kohms unbal., DC coupled
Nominal level........................................ -10 dBV (316 mVrms)
Maximum level .................................... +8 dBV (2.51 Vrms), unbal. at <0.1%THD+N
+10 dBu (2.45 Vrms), bal. at <0.1% THD+N
Input gain adjustment .......................... -42 dB to +24 dB, adjustable per input
NOTE: 0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV
≈ 2 dBu
AUDIO OUTPUT — LINEOUT AND PREAMP
Number/signal/connectors.................... 1 stereo/mono, bal./unbal. line level on 3.5 mm
captive screw (lineout)
1 stereo/mono, bal./unbal. variable level on
3.5 mm captive screw (preamp)
Impedance............................................ 50 ohms unbal., 100 ohms bal.
Nominal level........................................ Configurable: -10 dBV (316 mVrms, default), +4
dBu (1.23 Vrms) Maximum level (600 ohm)
Power amp (mono or stereo) .......... >+17 dBu, bal. <0.5% THD+N
Preamp ............................................ >+19 dBu, bal. <0.1% THD+N
Lineout ............................................ >+16 dBu, bal. <0.1% THD+N
NOTE: Unbal. wired outputs produce 6 dB of attenuation. Bal. outputs have unity
gain/attenuation.
AUDIO OUTPUT —
MONO POWER AMP (MLS 304MA, ONLY)
Number/signal/connector .................... 1 mono on 5-position screw terminal
Sensitivity @ max power ...................... -20 dBV (100 mVrms) (adjustable)
Power bandwidth
Direct (4 ohm)................................ 20 Hz to 20 kHz, 0.5% THD
Direct (8 ohm)................................ 20 Hz to 20 kHz, 0.15% THD
Transformer (70V) .......................... 50 Hz to 20 kHz, 1% THD
Transformer (100V) ........................ 50 Hz to 20 kHz, 0.5% THD
Maximum power output
Direct (4/8 ohm) ............................ 20 watts max. (rms)
Transformer (70/100V) .................. 16 watts max. (rms), transformer coupled
Protection ............................................ Input limiting, thermal, short circuit
AUDIO OUTPUT — STEREO POWER AMP (MLS 304SA, ONLY)
Number/signal type .............................. 1 stereo (default) or dual mono (configured via
software) on 5-position screw terminal
Sensitivity @ max. power ...................... -20 dBV (adjustable)
Power bandwidth at maximum power output
Direct (4 ohm)................................ 10 Hz to 20 kHz, 0.5% THD
Direct (8 ohm)................................ 20 Hz to 20 kHz, 0.8% THD
Maximum power output
Direct (4 ohm)................................ 24 watts max., (12 watts rms per channel)
Direct (8 ohm)................................ 16 watts max., (8 watts rms per channel)
Protection.............................................. Input limiting, thermal, short circuit
CONTROL/REMOTE — SWITCHER
Serial control port.................................. RS-232, 3.5 mm captive screw connector, 5 pole
(uses 3 poles)
Baud rate and protocol.......................... 9600, 8-bit, 1 stop bit, no parity
Program control .................................... Extron’s configuration program for Windows
®
Extron’s Simple Instruction Set (SIS) ™
GENERAL
Power .................................................... 100 VAC to 240 VAC, 50/60 Hz, 60 watts,
internal, autoswitchable
Rack mount .......................................... Yes, with included brackets (#70-077-03)
Metal Enclosure dimensions .................. 1.75" H x 17.5" W x 8.5" D 4.4 cm H x
44.4 cm W x 21.6 cm D
Product weight...................................... 6.0 lbs (2.7 kg)
Shipping weight .................................... 11 lbs (5 kg)
Listings .................................................. UL, CUL
Compliances.......................................... CE, FCC Class A, VCCI, AS/NZS, ICES
NOTE: All nominal levels are at ±10%.
Model Part Numbers
MLS 304MA .......................................... 60-550-01
MLS 304SA............................................ 60-550-02
MLS 304MA
MediaLink Switcher with
integrated mono amplifier
MLC 206
MediaLink Controller
The MLS 304 switchers can
be used as a stand-alone
switcher, or combined with
the MediaLink family
Controller to create an
affordable system
integration solution.
Specifications are subject to change without notice.