England's Stove Works 55-SHP20 User Manual
Page 17
Control Board
The Control Board (Part # PU-CB04) is a digital read-out board. This board offers a wide variety
of settings to operate the unit. This part can be removed from the unit by loosening the two outside
screws and pulling the board back to the inside of the stove. The rear access panel should be
removed prior to removing the control board. A 6-amp “quick-blow” fuse (Part # PU-CBF6) is used
on this Control Board.
NOTE: The bottom three control buttons are preset at the factory and should not require any
changes. See “Operating Instructions” and “Daily Operation” section of the manual for
instructions on other Control Board settings.
Illustration 3
Control Board
Diagram
CAUTION:
NOTE: The bottom
3 buttons are pre-set at the
factory and do not need
adjustment.
Call Service at
(800) 245-6489 if you have
questions or problems.
Recommended Heat Ranges:
Low Burn:
Heat Range setting: 1
Room Air Blower setting: 1
Medium Low:
Heat Range setting: 2 – 3
Room Air Blower setting: *
Medium High: Heat Range setting: 5 – 8
Room Air Blower setting: *
High Burn:
Heat Range setting: 9
Room Air Blower setting: 9
NOTE: the room air blower settings may be run higher but should never be run lower than the heat range.
for helpful information,
frequently asked questions, parts/accessory orders and more!
17