Electrolux EHS 60020 K - Manual (Page 17)

what to do if … electrolux 17
What to do if
…
Problem Possible cause Remedy
The cooking zones are not
functioning. No cooking zone selected Select cooking zone within 10
seconds of switching on (Dec-
imal point lights up)
The cooking zones cannot be
selected / Appliance does not
react to the control panel input More than 10 seconds has
passed since the appliance
was switched on Switch on the appliance again.
Select cooking zone within 10
seconds of switching on
The child safety device is acti-
vated Deactivate the child safety de-
vice (See section “Child safety
device”)
The sensor fields are partly
covered by a damp cloth or
with liquid Remove the cloth or the liquid
Safety cut-out has been trig-
gered Switch on the appliance again
The residual heat indicator is
not displaying anything The cooking zone was only on
for a short time and is therefore
not hot If the cooking zone is sup-
posed to be hot, call your local
Service Force Centre.
Er03
is displayed
Several sensor fields were
touched at the same time Only touch one sensor field
Er21
is displayed
Safety cut-out due to over-
heating. Let the appliance cool down.
Remove cookware.
Er25
is displayed
(only for 10 seconds)
Appliance is incorrectly con-
nected
Disconnect the appliance from
the electrical supply and have
it connected properly
Er40
is displayed The overvoltage protector has
been activated (for an incor-
rect connection see above
Er25 or for overheating of the
electronic components see
Er21 )
Separate the appliance from
the mains for a few minutes
(remove the mains fuse).
Let the appliance cool down.