Electrolux 5041 - Manual (Page 24)

24
...the machine is noisy
...the door is difficult to
close
The plug is not properly
inserted in the power
socket. Insert the plug.
There is a power failure.
Dishes are rattling against
each other.
The spray arms are
knocking against the
dishes.
The dishwasher is not level,
or not properly built-in.
Load correctly crockery,
cutlery, pots and pans.
Refer to "Loading cutlery
and dishes"
Refer to "Installation"
instructions.
Check the fuse.
What to do, if...
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer.
Before contacting your local Service Force Centre, please carry out the checks listed
below.
Important: If you call out an engineer to a fault listed below or to repair a fault
caused by incorrect use or installation a charge will be made even if
the appliance is in guarantee.
Symptom
...the programme does not
start
...the machine will not
drain
...the machine does not fill
with water
The water tap is closed.
The door has not been
properly closed. Close the door.
Open the water tap.
The mains water supply has
been cut off. Wait for the supply to be
restored.
The inlet hose may be
squashed or bent.
The inlet hose may be
blocked.
The drain hose may be
squashed or bent. The drain
hose extension is not
correct.
The sink may be blocked. Clear any blockages.
Reposition the drain hose
correctly. Follow the
instructions for
connecting to the waste.
Reposition the hose
correctly.
Switch off the water
supply and clean the
filter.
Possible cause Remedy
Once you have checked the possible causes listed above, switch on the dishwasher
and start a wash programme, if the fault persists contact the Service Force Centre.
152976 17/1 15-09-2001 9:10 Pagina 24