Emerson DC-DC Converter Module Mounting Shelf DCS4830 - Manual (Page 10)

SAG584622000 System Application Guide
Issue AB, November 18, 2009 Spec. No. 584622000 (Model DCS4830)
Page 10 of 17
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Home
SPECIFICATIONS
1.1 Output Ratings
1.1.1 Voltage: Nominal -48 volts DC, positive ground, non-adjustable.
1.1.2 Current: 10 amperes per DC-DC Converter Module, up to a total of 30 amperes per DC-DC
Converter Mounting Shelf when three (3) Converter Modules are installed.
1.1.3 Regulation
(A) Static: Steady state output voltage remains within ±1 volt of the pre-adjusted voltage for
any load current from no load to full load and over the specified input voltage range.
(B) Dynamic: For a step load change of 50% within the range of 10% to 100% of full rated
current, the maximum voltage transient will not exceed 5% of the initial steady state voltage.
1.1.4 Filtering: With at least 10% of rated full load on the output (-20°C to +65°C).
(A) Voice band noise is less than 32 dBrnC when measured with a noise meter using 600 ohm
bridged input and C-message weighting.
(B) Wide band noise does not exceed 250 millivolts peak to peak over the frequency range of 0
Hz to 20 MHz.
(C) Wide band noise does not exceed 30 millivolts rms over the frequency range of 0 Hz to 20
MHz (as measured with an HP3400A true rms voltmeter).
(D) Noise below –20°C is slightly higher.
1.1.5 Output Distribution: Two (2) 6-Position GMT Fuse Modules are provided for connecting DC
output load leads.