Electrolux LAVAMAT W 1460 - Manual (Page 30)

Operating Instructions
30
Water leaks out
of the washing ma-
chine.
The screw connection of the
inlet hose is leaking. Tighten the inlet hose screw
connection.
The drainage hose is leaking.
Check the drainage hose and
replace if necessary.
The drain pump cover is not
correctly closed.
Close the cover correctly.
Washing is caught in the door.
Stop the programme, remove
the washing caught in the
door. Restart the programme.
The emergency emptying hose
is not correctly closed or is
leaking.
Close the emergency empty-
ing hose (see Section "Carry
out emergency emptying“).
Call your local Service Force
Centre if the emergency emp-
tying hose is leaking.
Fabric softener was
not rinsed in, the
æ compartment is
filled with water.
The insert in the conditioner
compartment is not correctly
attached or is blocked. Clean the detergent dispenser
drawer and attach the condi-
tioner insert correctly.
Washing is heavily
creased. Probably too much washing
has been put in the drum.
Pay attention to the maximum
load quantity (see Programme
Tables). In the case of easy-
care fabrics, select the EASY
IRON programme.
The washing has
not been spun as
dry as usual. The washing was not able to
be distributed evenly in the
drum prior to spinning. Always load the drum as ful as
possible with a combination of
large and small items.
Washing is not
thoroughly spun,
water remains visi-
ble in the drum.
The END light
flashes twice, an
acoustic signal is
emitted twice.
The drain hose is kinked. Remove the kink.
The maximum pump height
(outlet height 1 m from
the base of the appliance)
is exceeded.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conversion
kit is available as a special ac-
cessory.
The drain pump is blocked.
Switch off the machine and
disconnect the mains plug.
Clean the drain pump.
For siphon attachments:
the siphon is blocked.
Clean the siphon.
Problem Possible cause Remedy