Enviro EF THERMO 28 - Manual (Page 16)

Installation
I
NSIDE
V
ERTICAL
I
NSTALLATION
:
1. Choose a stove location that is ideal. See the section Deciding Where to Locate Your Pellet
Appliance.
2. Place a non-combustible hearth pad where necessary.
3. Place the unit on the hearth pad and space it in a manner so when the pellet vent is installed
vertically, it will be 3” (76 mm) away from a combustible wall.
4. Locate the center of the fresh air intake pipe on the unit. Match that center with the same point on
the wall and cut a hole about 1 5 /
8
” (41 mm) in diameter.
5. Install the fresh-air intake pipe.
6. Install the tee with clean out.
7. Install the pellet vent upward from
there. When you reach the ceiling
make sure that the vent goes through
the ceiling firestop. Maintain a 3” (76
mm) distance to combustibles and keep
attic insulation away from the pipe.
8. Finally, extend the pellet vent to go
through the roof flashing.
9. Ensure that the rain cap is approximately
36” (914 mm) above the roof.
Figure 19
16