Electrolux AG17542STA User Manual

Page 25

REPLACING BATTERY

WARNING: Do not short bat tery ter-

mi nals by al low ing a wrench or any other
object to contact both terminals at the same
time. Before con nect ing battery, remove
metal bracelets, wrist watch bands, rings,
etc.
Positive terminal must be connected fi rst to
prevent spark ing from ac ci den tal grounding.
1. Lift seat pan to raised position.
2. Disconnect BLACK battery cable fi rst

then RED battery cable and carefully
remove battery from trac tor.

3. Install new battery with terminals in

same position as old battery.

4. First connect RED battery cable to posi-

tive (+) terminal with hex bolt and keps
nut as shown. Tighten securely. Slide
terminal cover over terminal

5. Connect BLACK grounding cable to

negative (-) ter mi nal with remaining hex
bolt and keps nut. Tighten se cure ly.

Seat Pan

Keps Nut

Positive
(Red)
Cable

Hex
Bolt

Terminal Cover

Negative
(Black) Cable

TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Pull bulb holder out of the hole in the

backside of the grill.

3. Replace bulb in holder and push bulb

holder securely back into the hole in
the backside of the grill.

4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring

diagram in the Repair Parts section.

TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.

TO REMOVE HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor. Grasp hood at

sides, tilt toward engine and lift off of
tractor.

4. When replacing hood, be sure to re-

connect the headlight wire con nec tor.

Headlight
Wire
Connector

Hood

ENGINE

TO AD JUST THROTTLE CON TROL
CABLE
The throttle control has been preset at the
factory and ad just ment should not be nec-
essary. Check adjustment as described
below before loosening cable. If adjust-
ment is necessary, see engine manual

TO AD JUST CARBURETOR

The carburetor has been preset at the
factory and ad just ment should not be nec-
essary. However, minor ad just ment may
be required to compensate for dif fer enc es
in fuel, temperature, altitude or load. If
the carburetor does need ad just ment, see
engine manual.