Electronic Arts EA Sports PGA Golf Tour Challenge 040-0068-01 - Manual (Page 9)

Change the Dollar Bill Validator Wiring (if Required)
© 2006 GLOBAL VR, INC.
040-0068-01 Rev B 1/12/2006 Page 9 of 14
Change the Dollar Bill Validator Wiring (if Required)
If your system computer has a Nytric Version 1.4 card installed (Nytric version is displayed on the
Machine Menu screen in the Operator Menu), and the dollar bill validator (DBV) does not register
inputs with the new software, you will need to make the following adjustment:
1. Locate the white wire that is connected to the coin mechs. Trace the wire; it will pass through a
shrink tube. Locate the white wire where it comes out of the shrink tube. Loosen the wire from
cable ties as necessary to give you some slack to work with.
2. Locate the two yellow wires from the DBV connector. Trace the wires to where they are butt-
spliced to a white, and a black-white wire, respectively.
3. Cut the yellow wire that is spliced to the white wire, just below the butt splice. (This wire connects
to Pin 7 of the 9-pin DBV connector.)
4. Splice the cut yellow wire into the white wire from the coin mechs, below the shrink tube (this is the
wire that you traced in step 1).
Important: Use electrical tape as needed to make sure the splice is well insulated. If the wires
short against metal they will cause coin inputs to register.
The figure below shows a suggested method of splicing the wires using a quick-connect splicer.
5. Test the DBV and coin mechs following this procedure to verify proper operation.