Echo SHC-260 - Manual (Page 13)

S
HAFT
H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
13
THROTTLE LINKAGE AND IGNITION LEADS
1. Close choke and remove air filter cover.
2. Place inner cable in slot of carburetor swivel (A).
3. Loosen nut (B) and place threaded end of throttle linkage in bracket
slot. Finger tighten nut (B).
4. Check throttle for freedom of movement and that wide open throttle
/ low idle extremes are adjusted properly. If adjustment cannot be
achieved with adjusting nut (B), consult with your Echo Dealer for
correct adjustment procedure.
5. Tighten nut (B). Connect 2 ignition stop leads (C, D) from throttle
cable tubing to 2 ignition leads (C, D) on engine.
6. Bundle and secure ignition leads against engine housing with clip
(E).
7. Install air filter and cover.
A
B
C
D
E