EverFocus ED300 Series - Manual (Page 9)

? Camera Cover
This cover will protect the camera from dust
and damage.
? Lens
This Vari-Focal Lens allows users to adjust
the Zoom and Focus manually.
? Base
The c amera unit is set in the dome base when
it is shippED300 from the factory.
? Focus Ring
To set the focus, loosen the Focus ring knob
first, then turn the ring toward < > or
as necessary. When the focus is
obtainED300 as desirED300, tighten the
focus ring knob.
? Zoom Ring
Loosen the zoom ring knob, then you can
adjust the viewing range. Turn the ring
towards for WIDE or for TELE as
necessary. When the setting is
finishED300, tighten the zoom ring knob.
? Auto Gain Control on/off switch.
The factory setting is AGC on.
? Back Light Compensation on/off
switch
The factory setting is BLC off.
? Level Volume Control
The iris level control for the lens.
? Ground Pin
For monitor use. Please see ?.
? Monitor Pin
When setting up the camera, connect a
monitor to this video output pin and to the
GROUND pin using alligator clip cables, then
using the image displayED300 on the monitor,
set the surveillance angle.
Power input
Use the connector to connect with 12VDC
or 24VAC-power adaptor.
Video Output BNC Connector
Use the connector to connect with the video in
connector of a monitor.
6.