JBL Control 2P 5.25" 2-Way Powered Speaker (Pair) - Manual (Page 6)

6
If there is no sound from your speakers, check these settings on the C2P Master Speaker :
• Make sure a signal source is connected and producing sound
• Make sure the white power ON LED is illuminated on the front of the speaker.
• Confirm the included power supply is connected and the power switch is set to the ON position.
• Make sure the volume control is not set to the full counter clockwise position
• If the C2P Extension Speaker does not produce sound, make sure the extension speaker wire 1/4" plug is
connected to the EXTENSION SPEAKER 1/4" output connector. Make sure the bare-wire end of the cable is
connected to the extension speaker wire terminals.
• If the system sounds as if it lacks low frequency (bass) performance, confirm the bare wire is connected so
the RED wire is connected to the RED speaker wire terminal, and the other wire is connected to the
BLACK speaker wire terminal.
If the above measures do not correct the problem, please contact JBL Professional
NOTE: If the red LED on the front of the speaker flashes due to continuous over-driving of the system, overload-protection may be
activated and no sound will be heard. To resume operation, reduce system volume, turn the power switch OFF and then ON again.
Trou b le Shooting
Frequency Response ( +/- 3dB): 100 Hz – 18 kHz
Frequency Range (-10dB): 80 Hz - 20 kHz
Maximum Peak SPL
C2PM Master Only
1 : 111 dB (1)
Maximum Peak SPL Per-Pair 1 : 115 dB (1)
LF Transducer: 135 mm (5.25 in) low frequency loudspeaker
HF Transducer: 19 mm (.75 in) polycarbonate dome tweeter
Overload Protection: Internal Peak Limiter and Overload Protection
Crossover Frequency: 4.2 kHz
Signal Input Connectors (x2): Balanced Neutrik ® 2 Combo XLR 1/4" TRS; Unbalanced RCA
Input Sensitivity: +4 dBu XLR / 1/4"; 0 dBu RCA
Amplifier Power: 35 Watts continuous per-channel
Power Requirements: 19 VDC / 3.42 A - use only supplied power supply
Headphone Jack: 3.5 mm (1/8")
Enclosure Material: Polypropylene Structural Foam
Finish: Black
Dimensions (H x W x D): 235 x 159 x 143 mm (9.3 x 6.3 x 5.6 in)
Net Weight Master Speaker: 2.6 kg (5.5 lb)
Net Weight Extension Speaker: 2.2 kg (4.5 lb)
Shipping Weight per Pair: 12.5 lb / 5.8 Kg
Optional Accessories: MTC-2P Mounting Kit 3
1 IEC Pink Noise at 1 meter.
2 Neutrik and the names of Neutrik products referenced herein are either trademarks and/or service marks of Neutrik.
3 CAUTION : Unsafe mounting or overhead suspension of any heavy load can result in serious injury and equipment damage. Mounting of speakers
should be done by qualified persons in accordance with all applicable local safety and construction standards. Be certain to follow the instructions
provided by the manufacturer of the mounting bracket. Before selecting a mounting bracket, be certain that it is capable of supporting the weight of the
speaker to be mounted.
Specifications
Control2.UsersGuide.0708 7/30/08 5:04 PM Page 6