Compliance information – DJI FPV Drone (Combo) User Manual

Page 26

Compliance Information

FCC Compliance Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) This device must accept any interference received, including interference

that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment. End user must follow the specific operating

instructions for satisfying RF exposure compliance. This transmitter must not be

co-located or operating in conjunction with any other antenna or transmitter.

The portable device is designed to meet the requirements for exposure to radio

waves established by the Federal Communications Commission (USA). These

requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue.

The highest SAR value reported under this standard during product certification

for use when properly worn on the body.

ISED Compliance Notice

This device contains licence-exempt transmitter(s)/receiver(s) that comply with

Innovation, Science and Economic Development Canada’s licence-exempt

RSS(s). Operation is subject to the following two conditions: (1)This device may

not cause interference.(2)This device must accept any interference, including

interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est

conforme aux CNR d’Innovation, Sciences et Développement économique

Canada applicables aux appareils radio exempts de licence. L’exploitation est

autorisée aux deux conditions suivantes :(1)L’appareil ne doit pas produire de

brouillage; (2)L’appareil doit accepter tout brouillage radioélectrique subi, même

si le brouillage est susceptible d’en compromettre le fonctionnement.

This equipment complies with RSS‐102 radiation exposure limits set forth for

an uncontrolled environment. This equipment should be installed and operated

with minimum distance 20cm between the radiator and your body. This

transmitter must not be co-located or operating in conjunction with any other

antenna or transmitter.

This equipment complies with ISED radiation exposure limits set forth for

an uncontrolled environment. End user must follow the specific operating

instructions for satisfying RF exposure compliance. This transmitter must not

be co-located or operating in conjunction with any other antenna or transmitter.

The portable device is designed to meet the requirements for exposure to radio

waves established by the ISED.

These requirements set a SAR limit of 1.6 W/kg averaged over one gram of

tissue. The highest SAR value reported under this standard during product

certification for use when properly worn on the body.

Cet équipement est conforme aux limites d’exposition aux rayonnements ISED

établies pour un environnement non contrôlé. L’utilisateur final doit suivre les

instructions spécifiques pour satisfaire les normes. Cet émetteur ne doit pas

être co-implanté ou fonctionner en conjonction avec toute autre antenne ou

transmetteur. Le dispositif portatif est conçu pour répondre aux exigences

d’exposition aux ondes radio établie par le développement énergétique

DURABLE.

Ces exigences un SAR limite de 1,6 W/kg en moyenne pour un gramme de

tissu. La valeur SAR la plus élevée signalée en vertu de cette norme lors de la

certification de produit à utiliser lorsqu’il est correctement porté sur le corps.

部件名称

有害物质

铅

(Pb)

汞

(Hg)

镉

(Cd)

六价铬

(Cr

)

多溴联苯

(PBB)

多溴二苯醚

(PBDE)

线路板

○

外壳

○

金属部件

（铜合金）

○

内部线材

○

其他配件

○

本表格依据

SJ/T 11364

的规定编制。

○：表示该有害物质在该部件所有均质材料中的含量均在

GB/T 26572

规

定的限量要求以下。

×：表示该有害物质至少在该部件的某一均质材料中的含量超出

GB/T

26572

规定的限量要求。（产品符合欧盟

ROHS

指令环保要求）

KCC Compliance Notice

“해당무선설비는

운용

중

전파혼신

가능성이

있으므로

인명안전과