JBL CSR-2SV Wall-Mounted Remote Control for CSM Mixers (White) - Manual (Page 6)

4
Using the Remote Control
Source Selection
The Source Selection control on the remote control only functions when
the Source Selector knob for that zone is set to “REMOTE” on the mixer.
When the remote control is active, the green LED on the remote control
below the Source switch (labelled ACTIVE) lights. When this LED is not lit,
the remote source control is not operational.
Volume Control
The LEVEL on the mixer is ALWAYS operational, regardless whether the
Source Selector is active or not. This remote control is ATTENUATE ONLY.
To set the volume control of the remote control, you can follow the steps:
1. Turn the remote control LEVEL to maximum (full clockwise).
2. Set the volume control on the mixer to the loudest you will ever need
the system to be.
3. Turn the remote control LEVEL knob down to a comfortable or typical
operating level. Now the remote control volume control cannot turn
the volume up above what is set on the mixer.
Compatibility Between CSR Remote Control and CSM
Mixers
Remote Control
Mixer
CSM-21 CSM-32
CSR-V √ √
CSR-2SV √ √
*
CSR-3SV √
* when using two input sources