Creality Halot-Lite Resin 3D Printer - Manual (Page 13)

7. Release Film Instructions
Installation steps
(Thickness)
0.15-0.2mm
95%
(Light Transmittance )
(Size)
190mm*266mm
Parameters
a.
b.
c. d.
a.
b.
c.
d.
Finally, place the film-ring assembly back into the vat frame
gently, then intall and tighten the fixing screws diagonally.
First, remove the 14 screws at the bottom of the vat and take
down the old release film.
Prepare the new release film, peel off the the protective films
on both sides of the release film. Align the holes and fit the
release film on the clamping ring.
The installed release film is as shown.
09