Electrolux EWG 12440 W - Manual (Page 13)

use electrolux 13
• Depress «Start/Pause» button again
to start immediately the programme.
The Delay cannot be selected with
Drain
programme.
Display
The display shows the following
information:
Duration of the selected
programme
After selecting a programme, the
duration is displayed in hours and
minutes (for example
2.05 ).
The duration is calculated automatically
on the basis of the maximum
recommended load for each type of
fabric.
After the programme has started, the
time remaining is updated every minute.
Washing programme phase icons
By selecting the wash programme, the
washing programme phase icons
corresponding to the various phases
making up the programme are shown in
the bottom of the display.
After you have pressed the
«Start/Pause» button and the machine
has started, the
(Door locked) pilot
light is on and only the phase running
icon stays on.
2.05
2.05
2.05
When the programme has finished, three
flashing zero «
0.00 ».
Delay
The selected delay (20 hours max) set
by means of the relevant button appears
on the display for about 3 seconds, then
the duration of the previously selected
programme is displayed.
The delay time value decreases by one
unit every hour and then, when 1 hour
remains, the time decreases every
minute.
Incorrect option selection
If an option which is not compatible with
the set wash programme is selected,
the message Err is displayed for few
seconds and the integrated red
«Start/Pause» light start flashing.
Alarm codes
In the event of operating problems,
some alarm codes can be displayed, for
example
E20 (see paragraph
“Something not working”).
E20
132971320 EN.qxd 07/06/2007 11.20 Pagina 13