Jonard Tools VT-1100 Non-Contact Voltage Detector with LED Flashlight - Manual (Page 2)

5. Auto power off
The detector will auto power off when it is not used for 5
minutes.
6. Turning off the detector manually
Long press the power button for 2 seconds to tum off the
detector
Technical Specifications
7. Low battery Indication
When the battery voltage is lower than 2.4V, the detector will
automatically shut down.
Battery Replacement
1. Hold the detector with one hand,
use your thumb of the other hand to
press down on the battery
compartment latch, and pull the end
of the detector.
2. Pull out the end of the detector
along the direction shown at right
pictures and replace the batteries.
WARNING:
Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zlnc), or rechargeable
(nl-cad, nl-mh, etc) batteries.
Standards: IEC/EN61010-1, IEC/EN 61010-2-030,
IEC/EN 61326-1, IEC/EN 61326-2-2
VT-1100 - VOLTAGE DETECTOR
USER MANUAL
Tel 914.793.0700 | Fax 914.793.4527 | jonard.com
VT-1100