Carson 8x32 3D Series TD-832ED Binoculars (Black) User Manual
Page 2
WATERPROOFING:
All Carson 3D binoculars are nitrogen purged and o-ring
sealed to protect your binocular from water damage. They
are designed to protect against accidental splashing, rain
or even full submersion in up to 1 meter of water for up to
5 minutes.
OPTICAL COATINGS:
All 3D binoculars featuer fully multi-coated optics, meaning
that all glass surfaces have multiple coatings applied to them
to prevent internal reflection and light loss. This results in
images that are brighter, shaper and higher in contrast.
As light travels through a roof prism binocular, it becomes
slightly out of phase. This affects the color balance and
fidelity. Your 3D binoculars are phase coated to correct this
problem, forcing the light back into phase and therefore
resulting in more accurate color reproduction.
All 3D binoculars come with both a neck strap and a shoulder harness. You can choose either accessory to hold your binocular
depending on your personal preference.
ATTACHING THE NECK STRAP:
1. Thread the end of the strap up through the strap clip on
the side of your binocular.
2. Thread the strap through the first loop of the plastic
strap piece.
3. Continue to thread the strap through the second loop of
the plastic strap piece.
4. Adjust the strap to the desired length and pull tight.
5. Slide the plastic cuff over the loose end of the neck
strap.
ATTACHING THE SHOULDER HARNESS:
1. Remove the security buttons from the quick release hooks
on your binocular harness.
2. Slide the security button loop upward through the strap
clips on each side of your binocular.
3. Feed the security button through the loop and tighten.
4. Attach quick release hook onto loop.
5. Slide security button into center of quick release hook.
1
2
3
4
5
USE OF A TRIPOD ADAPTER:
All Carson 3D binoculars are compatible with most
standard binocular tripod adapters. To attach a tripod
adapter to your binoculars:
1. Twist the tripod adapter cap (located at the hinge in
between the binocular barrels) counterclockwise and
remove it.
2. Attach the binocular tripod adapter into the threaded
hole in the binocular turning it clockwise until tight.
3. Attach the bottom of the tripod adapter to your tripod.
NOTE:
Tripod and adapter are not included with your
3D binoculars.
ripod and adapt
e not included with y
1
2
3
8
INSTRUCTIONS FOR CARE:
Cleaning must be done safely to avoid scratching the
lenses. This can be accomplished with the following
procedure:
1. Blow away any dust or debris on the lens (or use a soft
brush.)
2. To remove dirt, grease or fingerprints, clean with a soft
cotton cloth, rubbing in a circular motion. Use of a
coarse cloth or unnecessary rubbing may scratch the
lens surface and eventually cause permanent damage.
3. For a more thorough cleaning, use a Carson C6
®
lens
cleaning product.
4.
IMPORTANT:
Never attempt to clean your binoculars
internally or try to take them apart.
5. Keep binoculars in case when not in use.
Customer Service:
If you experience any difficulties, please contact us and we will be happy to help you.
In the U.S.A.
In the U.K.
In the E.U.
Phone: 1-631-963-5000
Phone: +44 (0) 1938 557440
Phone: +44 (0) 1938 557440
Email: [email protected]
Email: [email protected]
Email: [email protected]