Pioneer HDJ-X5BT Bluetooth Over-Ear DJ Headphones (Metallic Black) - Manual (Page 3)

En 3
Connecting via Bluetooth
Preparations
• Bring the Bluetooth device within approximately 1 m of
the headphones
• If necessary, read the user's manual of the device that
you are trying to connect in order to confirm how to use
it
Pair (register) the headphones with the
Bluetooth device and connect them
1 With the power turned off, press and hold the
multifunction button on the headphones until the
LED blinks.
When connecting a device for the first time:
Approx. 3 seconds
When connecting the second or subsequent device:
Approx. 5 seconds
• The headphones begin searching for the Bluetooth
device to connect to, and the LED blinks red and
white alternately.
2 Turn on the Bluetooth device and activate it.
3 From the Bluetooth menu on the Bluetooth device,
select the device name “HDJ-X5BT”.
• In some cases the MAC address “□□□□□□” (where
“□” is a specific character string that differs for each
device) appears before “HDJ-X5BT” is displayed.
• If a passkey entry is requested, enter the passkey of
the headphones “0000” (four zeros).
4 On the headphones, check the connection to the
paired Bluetooth device.
• The LED blinks red and white alternately until
connection with the device is complete.
• When the white LED lights, pairing is complete.
Notes
• The headphones power will turn off if connection to the
device does not complete within five minutes. If this
occurs, register the device again.
• Two or more Bluetooth devices cannot be connected
with the headphones at the same time.
• The headphones can register up to eight Bluetooth
devices. If more than the maximum number of devices
are registered, already registered Bluetooth devices will
be overwritten in order from the device first connected.
Register the devices again if you wish to use them.