Operating with the touch sensors, 28, “operating with the touch, Sensors”) – Technics EAH-AZ40 True Wireless In-Ear Headphones (Rose Gold) User Manual
Page 28: 28, “operating with the touch sensors”), 28 operating with the touch sensors
Operation
28
Operating with the touch sensors
You can operate the touch sensors on the earphones to change to the Bluetooth
®
pairing mode, or remote
control the Bluetooth
®
device.
• Depending on the Bluetooth
®
device or the app, even if you operate the touch sensors on the earphones, some
functions may not respond or may operate differently from the descriptions below.
∫
List of operations available with the touch sensors
*1 To cancel muting, touch the touch sensor (R) twice again while muting.
*2 With both earphone LEDs (L and R) blinking alternately in blue and red
Note
• You can change the functions assigned to the touch sensors on the “Technics Audio Connect” app (free of charge).
(Customization of touch sensor) (
• You can also use just one side of the earphones independently. In this case, it is only possible to perform operations
available on the side you are using.
• A beep sounds to indicate that you have touched to reach either the maximum or minimum volume level.
Function
Touch sensor (L)
Touch sensor (R)
Listening to music
Playback/pause
Touch once
Raise the volume
Touch rapidly 3 times
–
Lower the volume
Touch rapidly 2 times
–
Forward a track
–
Touch rapidly 2 times
Back a track
–
Touch rapidly 3 times
Making a phone call
Receive a phone call
Touch once while receiving the call
Raise the volume
Touch rapidly 3 times
–
Lower the volume
Touch rapidly 2 times
–
Mute the voice of the call
*1
–
Touch rapidly 2 times during the
call
Switch the noise level heard
from the other party
–
Touch rapidly 3 times during the
call
Reject a phone call
Touch and hold for about 2 seconds while receiving the call
End a phone call
Touch and hold for about 2 seconds during the call
Change control of external
sounds
–
Touch and hold for about
2 seconds
Start the voice assistant
Touch and hold for about
2 seconds
–
Set to the Bluetooth
®
pairing
mode
*2
Return to the factory settings