JLab Audio Go Air True Wireless Earbuds (White and Gray) - Manual

C
U
ST
OM
ER SU
PP
O
R
T
U.S
. BASED
We love that you are rocking JLab Audio!
We take pride in our products and fully stand behind them.
GO AIR EARBUDS
YOUR WARRANTY
All warranty claims are subject to JLab Audio
authorization and at our sole discretion. Retain your
proof of purchase to ensure warranty coverage.
CONTACT US
Reach out to us at [email protected]
or visit jlabaudio.com/contact
LI
M
ITE
D TWO YE
AR
Remove pull tab.
The charging case light will start pulsing blue.
ADDING NEW / ADDITIONAL BLUETOOTH DEVICES:
Turn OFF Bluetooth from any previously connected
device. Turn ON Bluetooth from new device.
Take earbuds out of the case.
Earbuds will automatically enter Bluetooth Pairing.
Select “JLab GO Air” in device settings to connect.
BLUETOOTH PAIRING
1
One earbud will blink blue/white indicating
ready to pair to your device.
3
Remove earbuds by pulling straight up or from side.
2
Select “JLab GO Air” in your device's
Bluetooth settings to connect.
Voice prompt “You’re connected” followed by
solid white lights will indicate you are connected.
4
A. B.
Bluetooth
Settings
JLab GO Air
REGISTER TODAY
jlabaudio.com/register
Product updates | How-to tips
FAQs & more