Setup – NEC MultiSync E172M-BK 17" 5:4 TN Monitor User Manual
Page 15
English−13
English
Setup
For box contents, please refer to the printed contents sheet provided in the box.
The accessories included depends on the location where the monitor was shipped.
To pull the stand, follow these instructions:
1. Place the monitor face down on a non-abrasive surface (
Figure 1).
2. Pull the stand holding the monitor with the other hand until the stand clicks (
Figure 2).
NOTE: •
Handle with care when pulling the stand.
•
Reverse this procedure if you need to re-pack the monitor.
Figure 1
Figure 2
To connect the monitor to your system, follow these instructions:
NOTE:
“Important Information” on page 3
before installation.
1. Turn off the power to your computer.
2. Place monitor face down on a non-abrasive surface.
3. Connect devices to the monitor.
DisplayPort
Power cord
HDMI
D-SUB
Headphone
Audio IN
CAUTION: •
Use the provided specified cables with this product so as not to interfere with radio and television
reception.
For mini D-Sub 15-pin, please use a shielded signal cable with core.
For DisplayPort, HDMI and Audio, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
•
Do not connect headphones to the monitor while you are wearing them. Depending on the volume
level, it may damage your ears and cause loss of hearing.