LG 24BK430H-B 23.8" 16:9 IPS FreeSync Monitor - Manual (Page 21)

21
ENG
ENGLISH
TROUBLESHOOTING
y Check Control Panel ► Display ► Settings and see if the frequency or the resolution were
changed. If yes, readjust the video card to the recommend resolution.
y If the recommended resolution (optimal resolution) is not selected, letters may be blurred and the
screen may be dimmed, truncated or biased. Make sure to select the recommend resolution.
y The setting method can differ by computer and O/S (Operation System), and resolution mentioned
above may not be supported by the video card performance. In this case, please ask to the computer
or the video card manufacturer.
y Keep proper posture when using the monitor, otherwise the screen may not be optimized.
CAUTION
The screen is flickering.
Did you select the recommended
resolution?
y If the selected resolution is HDMI 1080i 60/50 Hz, the screen may be flickering.
Change the resolution to the recommended resolution 1080P .
Display image is incorrect
The screen color is mono or
abnormal.
y Check if the signal cable is properly connected and use a screwdriver to fasten
if necessary.
y Make sure the video card is properly inserted in the slot.
y Set the color setting higher than 24 bits (true color) at Control Panel ►
Settings .
The screen blinks. y Check if the screen is set to interlace mode and if yes, change it to the
recommend resolution.
Do you see an "Unrecognized monitor, Plug&Play (VESA DDC) monitor found" message?
Have you installed the display
driver?
y Be sure to install the display driver from our web site: http://www.lg.com .
y Make sure to check if the video card supports Plug&Play function.
Check the following before calling for service.
No image appears
Is the power cord of the display
connected?
y Check and see if the power cord is connected properly to the power outlet.
Do you see an "Out of Range"
message on the screen?
y This message appears when the signal from the PC (video card) is out of
horizontal or vertical frequency range of the display. See the 'Specifications'
section of this manual and configure your display again.
Do you see a "NO SIGNAL"
message on the screen or black
screen?
y After the monitor is on "NO SIGNAL", the monitor goes to DPM mode.
y This is displayed when the signal cable between the PC and the monitor is
missing or disconnected. Check the cable and reconnect it.
y Check PC status.
Can 't you control some functions in OSD?
Can't you select some menu in
OSD?
y You can unlock the OSD controls at any time by entering the OSD lock menu
and changing items to off.