SPL Elector Preamp (Red) - Manual (Page 13)

13
Operation
IR Remote Control
The volume potentiometer can be remotely controlled using any infrared (IR) remote control
The special feature is that the Elector learns your remote and not the other way around. You do not need a univer-
sal remote control. Take, for example, the remote control of your CD player. Out of the many buttons there are two
you hardly use if at all and that do not directly trigger a function on the CD player.
Programming of the Elector to your remote control is easy and takes just two steps – one for each func-
tion: to the lower volume and increase the volume.
• Press the LEARN IR-REMOTE button (12) on the rear of the unit until you note the actuation point
The Power LED now lights up brighter.
• Step 1/2: Point your remote control towards the VU meters (2) and push the button you wish to use to to
lower the volume . The power LED flashes once per push. Press the same button repeatedly until the power
LED flashes three times within a short interval – programming of this button is then completed.
• Step 2/2: Push the button you wish to use to increase the volume . The power LED flashes once per push.
Press the same button repeatedly until the power LED flashes three times within a short interval –
programming of this button is then completed.
~ 115V AC / ~230V AC, 50 Hz / 60 Hz, P max. 45 W
SEND
–10dB
RETURN
+10dB
L L R
Refer to
Manual
R
L
R
L
R
L
R
L
4 5 6
3
L R
2
L R
Tape
Monitor
L R
1
B
A
I R F