StarTech.com Ultra HD 4K HDMI over Cat 5e/6 HDBaseT Extender Kit (230') - Manual (Page 7)

Instruction Manual
4
3. Install Receiver Unit
a) Position the Receiver Unit near the video display (i.e. television, projector).
b) Connect the video source to the HDMI® OUT on the Receiver Unit using an
HDMI® cable.
c)
(Optional) If you’ve chosen to power the kit from the Receiver side, connect the
provided power supply.
4. (Optional) Install the grounding wires.
Note: Installation of the grounding wires is optional but recommended in
environments with high levels of electromagnetic interference (EMI), or
frequent electrical surges.
Transmitter
a) Using a Phillips type screw driver (sold separately) remove the optional grounding
bolt from the Transmitter Unit.
b) Attach the loop of one of the grounding wires to the shaft of the grounding bolt
that was removed.
c) Using the Phillips type screw driver (sold separately)drive the grounding bolt back
into the hole it was removed from, on the Transmitter Unit.
d) Attach the other end of the grounding wire (that’s not connected to the
Transmitter Unit) to an earth ground connection.
Receiver
a) Using a Phillips type screw driver (sold separately) remove the optional grounding
bolt from the Receiver Unit.
b) Attach the loop of one of the grounding wires to the shaft of the grounding bolt
that was removed.
c) Using the Phillips type screw driver (sold separately)drive the grounding bolt back
into the hole it was removed from, on the Receiver Unit.
d) Attach the other end of the grounding wire (that’s not connected to the Receiver
Unit) to a proper earth-ground connection.
5. Your source video image will now appear on the remote video display.