Samson SWGMMR Go Mic Dual-Channel Receiver - Manual (Page 11)

Owner’s Manual
11
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO
Getting Started - Pairing
The Go Mic Mobile system will come paired from the factory. If you need to re-pair
the system for any reason follow these steps:
1. Turn on the Go Mic Mobile Receiver (GMM) and Go Mic Mobile transmitter by
pressing their Power/Pair buttons for less than 5 seconds.
2. On the GMM, press and hold the Power/Pair button for more than 5 seconds. The
CH1 LED will start flashing slowly.
3. On the Go Mic Mobile transmitter, press and hold the Power/Pair for more than 5
seconds. The transmitter LED will start flashing slowly.
4. When the receiver and transmitter are paired the LEDs will quickly flash and the
transmitter will light solid Green and the GMM CH 1 LED will light solid white.
The Go Mic Mobile Receiver CH2 LED will now start flashing slowly.
5. To pair a second transmitter, press and hold the Power/Pair button on the second
transmitter for more than 5 seconds. The transmitter LED will start flashing slowly.
When the receiver and transmitter are paired the LEDs will quickly flash and the
indicator on the second transmitter will light solid green and the GMM CH 2 LED
will light solid white.
Note: If you do not wish to pair a second transmitter, the receiver will time out of
pairing mode after 20 seconds.
7. To re-pair the paired transmitters with the Go Mic Mobile receiver, press and hold
the Power/Pair button on the receiver for more than 5 seconds. The receiver will
erase the current paired transmitters and enter pairing mode. If no transmitters
are paired with the receiver, the GMM will time out and return to the previously
paired state.
Note: When pairing your Go Mic Mobile system, make sure only one GMM receiver is
turned on and only one microphone is in pairing mode at a time.