Samson AirLine Micro AH2/SE10 Earset Transmitter with Y Cable (K3: 492.425) - Manual (Page 11)

AirLine Micro Earset 11
Quick Start
11. If you hear distortion at the desired volume level, check to see whether the Status Indicator LED on the receiver is lighting
RED. If it is not lit, make sure that the gain structure of your audio system is set correctly (consult the owners manual
of your mixer and/or amplifier for details). If the Status Indicator is RED, simply move the microphone further from your
mouth.
If you hear a weak, noisy signal at the desired volume level, make sure that the gain structure of your audio system and the
Audio Output Level switch are correctly set. If the Audio Output Level switch is correctly set and the signal coming from the
receiver is still weak and/or noisy, simply position the microphone closer to your mouth.
If you feel that the level of the microphone needs further adjustment, press and hold the AH2 Multi-Function Switch while
the unit is powered on until the Status Indicator turns off, and release the switch. Then press and hold the Multi-Function
Switch again for 5 seconds. The AH2 Status Indicator will first flash GREEN then flash YELLOW to show that you are in the
Volume Adjustment mode. Press and release the Multi-Function Switch once, and the microphone volume will increase one
level. To continue to adjust the microphone volume, press and release the Multi-Function Switch until the maximum level
is reached. There are 5 levels. With each increasing level, the Status Indicator will flash faster. After level 5 is reached, the
transmitter will cycle back down through the levels each time the Multi-Function Switch is pressed. As the levels decrease,
the Status Indicator flashes slower. When the desired level is reached, release the Multi-Function Switch. The AH2 will
return to normal operation after 10 seconds, and the Status Indicator will be steady GREEN.
12. Do a walk-around through the intended area of coverage while observing the AR2’s Status Indicator; it should stay steadily
GREEN, indicating sufficient RF reception in all areas of coverage. If the AR2’s Status Indicator lights YELLOW, it desig-
nates RF dropout or muted receiver. Reposition the device (or its antennas) as necessary. If extended range coverage is
required, another AR2 true diversity receiver (set to the same channel as the transmitter) should be used.