Fcc regulations, Frequency bands and power, Legal information – Xiaomi Mi A3 User Manual

Page 6

This version is for private use only and should not be distributed.

Frequency Bands and Power

This mobile phone offers the following frequency bands in EU areas only and maximum radio-frequency
power:

GSM 900: 35 dBm
GSM 1800: 32 dBm
UMTS band 1/8: 25 dBm
LTE band 1/3/7/8/20/28/38/40: 25.7 dBm
Bluetooth: 20 dBm
Wi-Fi 2.4 GHz band: 20 dBm
Wi-Fi 5 GHz: 5150~5350MHz: 20dBm, 5470~5725MHz: 20dBm, 5725~5825MHz: 14dBm

FCC Regulations

This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.

Legal Information

This device may be operated in all member states of the EU.
Observe national and local regulations where the device is used.
This device is restricted to indoor use only when operating in 5150 to 5350Mhz frequency range in following
countries:

Receiver Category 2
Ensure the power adapter used meets the requirements of Clause 2.5 in IEC60950-1/EN60950-1 and has
been tested and approved according to national or local standards.

During SAR testing, this device was set to transmit at its highest certified power level in all tested
frequency bands, and placed in positions that simulate RF exposure in usage against the head with no
separation, and near the body with the separation of 5 mm.

SAR compliance for body operation is based on a separation distance of 5 mm between the unit and the
human body. Carry this device at least 5 mm away from your body to ensure RF exposure level compliant or
lower to the reported level. To support body operation, choose the belt clips or holsters, which do not
contain metallic components, to maintain a separation of 5 mm between this device and your body. RF
exposure compliance with any body accessory, which contains metal, was not tested and certified, and use
such body-worn accessory should be avoided.

AT
EE