GRAM KS 3135-90/1 - Manual (Page 80)

EN 8
3 Installation
B
Please remember that the
manufacturer shall not be held liable if
the information given in the user guide
is not observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, and etc. have to
be fastened securely by adhesive tape
against any jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget…
That recycled material is an
indispensable source for the nature
and for our national resources.
If you would like to contribute to the
recycling of the packaging materials,
you can get further information from
the environmental bodies or local
authorities.
Before operating your
refrigerator
check the following:
1. The interior of the refrigerator has to
be dry and it is possible for the air
to circulate freely at the back of the
appliance.
2. You can install the 2 spacers as
illustrated in the figure. Spacers will
provide the required distance between
your refrigerator and the wall in
order to allow the air circulation. (The
illustrated figure is only an example
and does not match exactly with your
product.)
3. Clean the interior of the refrigerator as
recommended in the “Maintenance
and cleaning” section.
4. Plug the refrigerator into the outlet.
When the door is open the interior
light in the refrigerator compartment
will be switched on.
5. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
6. The front
edges of the refrigerator may feel
warm. This is normal. These areas
are designed to be warm to avoid
condensation.