GRAM KS 3265-93/1 - Manual (Page 83)

EN 9
3 Installation
B
Please remember that the
manufacturer shall not be held liable
if the information in the instruction
manual is not observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
drawer, etc. in your refrigerator must
be fastened securely by adhesive tape
against any jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on the
package must be followed.
Please do not forget…
That recycled material is an
indispensable source for the nature
and for our national resources.
If you wish to contribute to the
recycling of the packaging, you
can get further information from
the environmental bodies or local
authorities.
Before operating your
refrigerator
check the following:
1. The interior of the refrigerator has to
be dry and it is possible for the air
to circulate freely at the back of the
appliance.
2. Clean the interior of the refrigerator as
and cleaning” section.
3. You can install the 2 plastic wedges
as illustrated in the figure. Plastic
wedges will provide the required
distance between your refrigerator
and the wall in order to allow the air
circulation. (The illustrated figure is
only an example and does not match
exactly with your product.)
4. Plug the refrigerator into the
outlet. When the door is open the
interior light in the refrigerator
compartment will be switched on.
5. You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not running
and this is quite normal.
6. The front edges of the refrigerator may
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.