İhlas Aura StillVac - Manual (Page 7)

WARNING
WARNING
During vacuuming, if the water level is exceed in the tank, the sound of the device will be
increased. In that case, unplug your device and discharge the water from the tank.
Tighten the filter
securing lock clockwise.
Place the filter slot in the
direction of the arrow.
Place the sponge filter in
the direction of the arrow.
Lift the head unit from
the dirt collection tank.
4 3 2 1
In the event of a wet spill in your home, your device can be used to remove liquids from
your floor.
Wet spill vacuuming
Use the following steps convert your device from sweeping mode to wet vacuuming mode.
WARNING
Do not use your device to vacuum any hazardous liquids like flammable liquids,
corrosives, acids, oil based liquids, etc...
Attach the suction
hose to the inlet
connector.
Press power on green
(on/off) button. If machine
is on, the led light will be
illuminated.
You can vacuum the
accumulated water with
the end of the suction
hose.
6
Make sure that the
tank is empty.
5 7 8
• Turn off the on/off switch and unplug the
device. Remove all attacment and suction-hose
from the device.
• Empty the dirty water reservior, wipe with a
cloth to remove dirt, rinse thoroughly with warm
water and allow to dry completely before
storage.
• Remove sponge filter, rinse and allow to dry
completely.
• Rinse and clean all parts and accessorries
thoroughly and allow to dry completely.
• To clean the suction-hose, flush clean by
running hot tap water through it and allow to
dry completely before using again or storage.
Maintenance must be performed by an authorized service technician.
Cleaning and maintenance