MIDEA MWA12CR71 - Manual (Page 16)


Page 16

Ins
tallation
Ins
tructions
2. While keeping a firm grip on the air conditioner,
carefully place the unit into the window opening so
the bottom of the air conditioner frame is against
the window sill (Fig. 4). Carefully close the window
behind the top rail of the unit.
NOTE
If stor m window blocks AC, see Fig. 10.
NOTE
Check that air conditioner is tilted back about H (Fig.
5) (tilted about 3° to 4° downward to the outside).
After propor installation, condensate should not
drain fro
m the overflow drain hole during nor m al use,
correct the slope otherside.
NOTE
To prevent window sill fro m splitting, drill 1/8” (3 mm )
pilot holes before driving screws.
C. Once the panel has been installed on the side of the
cabinet, make sure it sits securely inside the frame
channel by making slight adjustments.
Slide the top and bottom ends of the frame into the
top and bottom rails of the cabinet. Fig. 3.
D. Slide the panel all the way in and repeat on the
other side.
Top Rail
Bottom Rail
Fig. 3 Fig. 3
3. Extend the side panels out against the window frame
(Fig. 5).
4. Place the frame lock between the frame extensions
and the window sill as shown (Fig. 6). Drive 3/4”
(19mm) or 1/2” (12.7mm) locking screws through the
frame lock and into the sill.
5. Drive 3/4” (19mm) or 1/2” (12.7mm) locking screws
through frame holes into window sash (Fig. 7).
Fig.4
Wooden Windows
INSIDE
OUTSIDE
H:About 3/4 to 1
for 5K to 8K)
Measure from the cabinet edge
3
H:About 1 to 1 /
for 10K to 12K)
8
H
Fig. 4
window
fra
m e
Fig. 5 Fig. 5
Fig.6 Fig. 6
Fig.4 Fig. 7