Getting started, Routine maintenance, Emptying – Roborock Auto Empty Dock Pure CE User Manual
Page 11: Dust bag replacement

11
Getting Started
Notes:
•
The status indicator light turns off automatically when the robot is charging.
•
Do not use without dustbin cover or dust bag.
•
Place the dock on a flat floor away from fire, heat, and water. Avoid narrow
spaces or locations where the robot may be suspended in the air.
•
Placing the dock on a soft surface (carpet/mat) may cause the dock to tilt
over and cause problems docking and departing.
•
Keep excess power cable inside the storage slot so that the robot will
not get tangled in the cables, and the dock will not be dragged away or
disconnect from the power supply.
•
Keep the dock away from direct sunlight or anything that may block the
dock location beacon; otherwise, the robot may fail to return to the dock.
•
The Auto-Empty Dock recharges and empties. Store the standard robot
dock before use. Failure to do so may cause issues returning to dock.
•
Maintain the dock according to the maintenance instructions. Do not clean
the dock with a wet cloth.
•
Avoid frequent manual emptying.
•
Images are for illustration purposes only and may not exactly represent the product.
Emptying
Auto-emptying will begin when the robot returns to the dock after
cleaning. Press the Dock button to trigger emptying manually.
Press any button to stop emptying.
Dock
Routine Maintenance
1. Remove the dustbin cover vertically as shown.
2. Lift the dust bag out of the dustbin and discard it.
Dust Bag Replacement
1
* Replace as needed
The dust bag handle seals the bag on removal to prevent dust leakage.
Note: