Electrolux 74689 - Manual (Page 52)

Installation and connection instructions
52
Fitting under kitchen worktops
Important: The water supply tap and power outlet must remain acces-
sible after the appliance is installed.
Permanent connection
In the case of a permanent connection it is necessary that you install a
double pole switch between the appliance and the electricity supply
(mains), with a minimum gap of 3 mm between the switch contacts
and of a type suitable for the required load in compliance with the cur-
rent electrical regulations.
The switch must not break the yellow and green earth cable at any
point.
This operation should only be performed by a qualified electrician.
Recess size requirements
(Measurements in mm)