Parrot Disco FPV - Manual (Page 26)

ENGLISH
29
VIA A MICRO USB FLASH DRIVE
1. Connect your micro USB flash drive (not provided) to a computer.
Make sure that your flash drive does not contain any files in .plf
format.
2. Go to the Parrot Disco’s support page on www.parrot.com and
download the update file available in .plf format.
3. Copy this file to the root of your micro USB flash drive.
4. Turn on the Parrot Disco.
5. Connect the micro USB flash drive to one of the Parrot Disco’s
ports.
> The Parrot Disco automatically restarts and the warning light
flashes yellow. Then, the Parrot Disco restarts again.
6. Wait until the Parrot Disco has completely restarted.
7. Disconnect the micro USB flash drive.
> The update is complete. Make sure the new version has actually
been installed: in the FreeFlight Pro application, go to Menu >
Settings. The version number is shown in the general information.
WARNING LIGHT INDICATIONS
Flashing
red light
The Parrot Disco is starting up.
Or
The Parrot Disco has detected an error.
> Restart the Parrot Disco on a flat,
immobile surface, out of the wind. If the
problem persists, visit the Parrot Disco’s
support page on www.parrot.com.
Flashing
green light The Parrot Disco has detected the GPS signal
and is ready to take off.
Flashing
yellow light The Parrot Disco update is underway.
Do not turn off the Parrot Disco.