Electrolux 50877 - Manual (Page 31)

The wash results are not satisfactory
The dishes are not clean • The wrong washing programme has been se-
lected.
• The dishes are arranged in such a way as to
stop water reaching all parts of the surface.
The baskets must not be overloaded.
• The spray arms do not rotate freely due to
incorrect arrangement of the load.
• The filters in the base of the washing com-
partment are dirty or incorrectly positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the
dishes; the salt container is empty or the in-
correct level of the water softener has been
set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
The dishes are wet and dull • Rinse aid was not used.
• The rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating
on glasses and dishes • Decrease rinse aid dosing.
Water drops have dries onto glasses and dishes • Increase rinse aid dosing.
• The detergent may be the cause. Contact the
detergent manufacturer’s consumer care line.
If after all these checks, the problem persists, contact your local Service Force Cen-
tre.
Technical data
Dimension Width - height - depth (cm) 60 x 85 x 63,5
Electrical connection - Voltage
- Overall power - Fuse Information on the electrical connection is given on the rating
plate on the inner edge of the dishwasher's door
Water supply pressure Minimum - Maximum (MPa) 0,05 - 0,8
Capacity Place settings 12
Max. weight kg 45
Technical data 31