Euro-Pro SHARK EP79 - Manual (Page 4)

Strap
Deluxe Air Driven
Turbo Brush
Crevice Tool
Dust Brush
• Filter should be cleaned at least twice
a year or when it becomes visible solid.
• Always operate the cleaner with the
filter installed.
• Disconnect from electrical outlet before
cleaning the filter.
• Do not use a washing machine to rinse
the filter.
• Do not use a hair dryer to dry it.
1. Push the dust cup lock to
open the dust cup.
2. Remove the filter from the
grill-filter.
3. Rinse filter in lukewarm water
and dry the filter completely.
Important: Do NOT use the HEPA filter
cartridge without the debris screen in
place.
Changing the Micro-Exhaust
Filter
Filter
GETTING TO KNOW YOUR BAGLESS CANISTER
VACUUM
OPERATING INSTRUCTIONS cont.
Motor Thermostat
Important:
This motor is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur, unplug the vacuum cleaner
from the wall outlet and turn off
switch. Allow the unit to cool. To
restart, re-plug into wall outlet and
turn switch back ON.
Changing and Cleaning the
Pre-Motor Filter
Attaching the Shoulder Strap
Use the hooks to attach the shoulder
strap to the vacuum cleaner.
First pass the flexible hose through the
loop of the shoulder strap and then
attach the two hooks to the strap hookup
holes at the bottom of the vacuum
cleaner as shown in illustration below.
Flat & Upright Parking Position
Please note that your vacuum cleaner
can be conveniently placed in a space
saving vertical parking position or in a
convenient flat parking position.
1. Place unit on its side. Slide floor
nozzle into locking position with
receptacle which rests on top of unit.
2. While laying flat on 3 wheels, slide
floor nozzle into locking position
with receptacle which rests on the rear
side of the unit.
4. Put the filter into the grill-filter.
5. A severely solid or clogged filter
should be thoroughly washed with
fresh tepid water. A mild detergent
can be used if required.
Technical Specifications
Voltage: 120V. 60Hz.
Power: 10.8 Amps, 1300 Watts
1. Open the lid.
2. Remove the used micro-exhaust filter.
3. Insert a new micro-exhaust filter.
4. Close the lid.
1
6